CNC E3 – FabMan Fixed
The FabMan on the E3 CNC has never worked very well – a hole in the side of the box was the temporary solution to reading….
Latest Posts
TableMoulder FabMan fixed
The FabMan on the TableMoulder was not reading the Key Fob’s correct.A small amplifying (LC) Circuit has been installed, and now the FabMan works as designed.
Martin Format Saw – Outfeed Table bending…
A small piese of MDF from cutting at 45 degrees angle was stuck under the Outfeed Table.When the angle of the blade was returned to 0….
Plasma Cutter – service
The PlasmaCutter has been checked, and the ground-clip replaced – and ground connector on the plasma head alså replaced.
Thickness Planer
Four teeth on the thiickness Planer was found with cuts and bruises. Probebly from leftover metal pieces in the wood… The fout plates was turned or….
Belt Sander – Oscilating Drive Fixed
New Self Lubricating Cooper Bearings have been installed on the oscillition motor shafts.
Metal Extraction Reset
A power off on the extraction main switch caused the PLC to fail.After a reset the system is rumming again.
Thickness Planer – new handle
The handle for securing the thickness level has been replaced.
Plasma Cutter Repair
An intermittent error on the Plasma has been identified as a faulty connector on the plasma-head. The error has been fixed for mow – and spareparts….